Http Control
HTTP Interface
Section titled “HTTP Interface”This program provides a simple HTTP interface to control the levels of CV1-6.
It requires that your EuroPi have a Raspberry Pi Pico W or Pico 2 W. See wireless configuration for instructions on configuring the Pico W/Pico 2 W’s wifi.
Accessing the web interface
Section titled “Accessing the web interface”To access the web interface, connect your device (phone/tablet/desktop/laptop/etc…)
to the same wifi network at EuroPi (or to EuroPi’s access point if you have
the wifi interface set up in AP mode). Then navigate to the IP address
displayed on the screen, e.g. http://192.168.4.1.
The web interface has six sliders. Each of these can be moved to set the output voltage of one of the corresponding outputs.
I/O Summary
Section titled “I/O Summary”CV1-6 will output voltages as specified by the web interface.
The buttons, knobs, ain, and din are not used by this program.
Note on concurrent users
Section titled “Note on concurrent users”There is no authentication no restriction on the number of concurrent browser connections. It is recommended to only use one device at a time to control EuroPi over HTTP.